Honeywell MIDAS-T-NP1，解器模塊，加熱器
?
簡介
MIDAS-T-NP1 熱解器選件安裝在標準Midas 氣體檢測器下方?？諝鈇mple 通過熱解器被吸入傳感器盒。熱解器將空氣中存在的目標氣體轉化為ample 通過熱解轉化為氟化氫(HF)。然后可以通過傳感器測量HF，并將濃度顯示為目標氣體的等效讀數(shù)（以ppm 為單位）。
為在使用熱解器時保持傳感器精度，建議每6 個月進行一次氣體校準，并且安裝點的環(huán)境溫度不要超過10-40°C (50°F) 高于此溫度的操作可能需要更頻繁的通氣測試或校準以確認工作規(guī)范。由于使用熱解器模塊時工作溫度較高，因此Honeywell Analytics 強烈建議在所有熱解器應用中使用通風Midas 頂蓋（部件號MIDAS-A-104）。
?
?
High Temperature Pyrolyzer Module for Perfluoro Compounds (PFC) Gas Detection. ?(order separate transmitter unit)
Higher Temperature Pyrolyzer MIDAS ?transmitters provide detection of NF3 , Hexafluorobutadiene (C4F6 ), Methyl Fluoride (CH3F) and Octofluorocyclopentene (C5F8 ). Unit includes a snap on pyrolyzer module that operates with any Universal MIDAS ?Extractive Transmitter (order separately). Units are powered via direct connection to transmitter unit. Consult Honeywell Analytics for additional gases detectable with this option. Pyrolyzer includes Pyrolyzer Quick Start Guide and installation screws. Order the PFC cartridge (MIDAS-S-XCF or MIDAS-E-XCF) separately. Order the ventilated top cover (MIDAS-A-103 or MIDAS-A-103G) separately.
?
Midas ?Gas Detector Transmitter & Sensor Combination
Extractive Midas ?transmitters (universal) operate with sensor cartridges, for use as a local gas detector. Sensor Cartridges must be ordered separately. Units are powered by 24VDC or via Power over Ethernet PoE. Transmitters provides 0-22mA analog and Modbus/TCP Ethernet as standard outputs. Integral relays for A1, A2 and fault are included, and may be wired normally open or normally closed, latched or unlatched. Transmitters include Manual, Quick Start Guide, and (1) PG16 gland fitting for power in and relays out, 1/4" O.D.x 1/8" I.D. Sample Inlet tubing (10') [3m], 1/4" O.D x 3/16" I.D. Exhaust tubing (10') [3m], and a sample line tubing duct adapter (1283K1090). ?Order a sensor cartridge separately for each transmitter.
?
Order the following parts for a complete Midas ?System:
Midas ?or Midas ?transmitter and cartridge kit
Sensor cell (if combo kit not purchased)
Sample and exhaust tubing
End of line filters
?